![]() Its Control 24, Pro Control, 002, most threads when talking about buying used many people recommend confirming that they have a replaced power supply. BTW, the Avid fix I did in the field for a few hundred bucks, Apogee required I send it in and it was $450 plus 2 weeks of lost usage.īut you're right, other than these two times, I've not seen them fail much in other gear. Outputs of Clish command 'show sysenv all' and Expert mode command 'cpstat os -f powersupply' show different status for Power Supply units. Locating the PSU details in the computer case. I also have an Apogee Symphony I/O that had a power supply fail fairly early on in its life. To check what power supply a PSU has, you can try a couple of methods: Perform a physical check. One power supply is not sufficient to supply full power to the switch. My ICON has been in use for 11 years (and I leave it on 24/7) and I did have one go bad. I do know that even things like expensive SSL consoles need power supplies replaced sometimes. Not sure if that would yield good data or not. I suppose you could count the posts by users that mention power supply failures. (2) solid-state input triggers, protects system relays from shorts, grounds and surges. PS220/220B - 110-120VAC input power supplies that deliver (2) amps 24VDC to (2) PTC fused outputs. ![]() We're on a forum where people might report issues like a failed power supply. Command Access PS220/220B Power Supply For All Latch Pullback/ Exit Devices UL 6E/CSA Linear with 2-I/0 Power Supply. Device management commands > display power display power Use display power to display power supply information. So we're talking potentially tens of thousands of units. ![]() Each ICON has multiple power supplies, for things like LEDs, faders, meters etc. I'm going to guess that Digi/Avid sold over 5000 ICONs. The show power inline detail command is enhanced to display 802.3bt-complaint device information such as the Operational Status of the device. In all my various gear from many companies, I've never needed to replace a power supply. A PoE-capable switch port automatically supplies power to one of these connected devices if the switch senses that there is no power in the circuit: A. Why do so many Digidesign/Avid gear need power supplies replaced so form?
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |